✓
pump body with funnel (5),
✓
silicone massaging shield (3),
✓
funnel cover (4),
✓
silicone valve (6),
✓
feeding bottle (8),
✓
wide and narrow neck bottle converter (7)
Wash in hot water with mild detergent, rinse thoroughly. Disinfect by placing in boiling water for approx. 5 min. Completely
air- or towel-dry before reassembly and next use.
Cleaning instruction:
• Set aside the tube and conduit connector. These items do not need to be washed or sanitized because the
diaphragm prevents them from coming in contact with the breast milk.
• All parts of the breast pump may be hand washed in hot water with mild detergent.
• Do NOT use solvents or abrasives.
• Rinse with hot, clean water.
• Bottle cap, screw cap, sealing disc and a food container with screw cap should be sanitized in the same way.
CAUTION!
DO NOT WASH THE TUBE, THE CONDUIT CONNECTOR OR ELECTRIC PARTS.
To clean the electric pump base, wipe the base with a damp cloth.
Silicone valve should be cleaned very carefully. Do not allow the food to dry out in the valve.
NOTE! Always disassemble the valve grasping the circular base with two fingers. Never grasp the end of the
valve as it can get damaged and weaken the strength of suction.
✓
Circular base
✓
Tip
How to disinfect the teat?
Before first and subsequent use wash the teat with warm water then place it in boiling water for 5 min. This is to
ensure hygiene. Clean before each use. Do not use any antibacterial agents! Inspect carefully before each use
especially when baby has teeth. Pull the teat in all directions. Throw away at the first signs of damage or
weakness. Do not tighten up bottle locking ring, as it may disturb its ventilation. Always check for leakage.
Never enlarge the teat flow holes by any means, as it may damage the teat. Do not leave the teat in a direct
sunlight, close to a source of heat, or in disinfectants (sterilizing solution) longer than recommended, as this may
weaken the teat. It is recommended to replace a teat max. after 2 months of use to ensure safety and hygiene.
After use, clean the bottle and the teat from food remains, rinse and then wash thoroughly with hot water; do not
boil. The bottle is dishwasher safe (max. temp.65°C). Do not wash the teat in the dishwasher because detergents
/ cleaning agents can cause damage to the product.
For your child safety and health WARNING!
Always use
this product under adult supervision. Never use feeding teats as soothers. Continuous and prolonged suckling of
fluids may cause tooth decay. Always check food temperature before feeding. Warming in microwave oven may
result in locally high temperature. If warming feed in microwave, oven remember to leave the bottle open. Take
