10. Power source - the device must be connected only to a power supply, for which it is
proposed.
11. Power cord - it is necessary to pay particular attention to a power cord, it must be
positioned so as to avoid stepping on it and to ensure it is protected against mechanical
damage.
12. The longer the period during which you do not use the preamplifier – you should
disconnect the power cord from the mains supply, or at least turn off the main power switch
located on the front panel.
13. Subjects containing liquid - do not place these objects (vases, flower pots), so that they
can fall on the preamplifier, possibly a fluid could leak out of them on the unit.
14. Damage requiring service - equipment should be repaired only to qualified service.
Once:
a) power cord is damaged
b) the device fell into the water or was poured
c) the device was exposed to rain
d) the device works incorrectly
e) the device fell to the ground or is otherwise mechanically damaged.
15. Repairs - all repairs must be entrusted to qualified service.
16. General warning - use the device only in accordance with the instructions.
Caution! To help you avoid an electric shock, do not expose the amplifier to
rain or moisture.
Signal and headphones connections
Signal input and output connections: The input connections are made via input socket at the
rear of the unit. Inputs and outputs use RCA connectors and should be connected in
accordance with the standard convention – right channel – RED – left channel – WHITE.
Headphones output connections are made via the standard 3 - pole 6,3mm jack plug.
Caution! Make all connections only if the device is disconnected from the
mains
Switching on
If you have already connected all signal sources and speakers, connect the amplifier to the
mains. Please ensure the position of the volume control is fully counterclockwise (zero
volume).
Turn the amplifier on with power switch located at the front of the unit.
Operate the input source and increase the volume control in a clockwise direction until an
audio signal is observed and you hear the sound from the speakers. If for any reason no output
is observed, please refer to the trouble-shooting guide.
Trouble-shooting guide
The amplifier is completely broken: power cord is not properly connected to the mains
Solution: connect the cable properly