Canon XF705, Instruction Manual

Page: 160 / 231

S electing a Networ k Connection
160
S electing a Network Connection
You can save up to 4 network configuration profiles. If you just saved a new network configuration, it will already
be automatically selected so follow this procedure to select a different configuration profile.
1 S elect [Connection S etting s ].
>
[
!
Network Settings]
>
[Connection Settings]
2 S elect the de s ired configuration number and then pre ss S ET.
3 S elect [OK] and then pre ss S ET.
Checking the Network’ s S tatu s
After activating a network function, the camcorder will connect to the network that was configured in advance.
The icons displayed on the screen will indicate the type of network selected and the connection status.
Wi-Fi (Infrastructure):
In yellow – the camcorder is connecting to or disconnecting from the network. In white – the
network function can be used.
Wi-Fi (Camera Access Point):
In yellow – starting the camcorder’s access point. In white – the camcorder’s access point is
ready. Connect the Wi-Fi enabled device to the camcorder.
Ethernet: In yellow – the camcorder is connecting to or disconnecting from the network. In white – the
network function can be used.
The (Ethernet) indicator next to the terminal will flash or illuminate as follows*: Flashing in
green – connecting to the network or streaming video (IP streaming only); illuminated in green –
FTP transfer active; flashing in red – network error.
: Browser Remote (
A
162)
: IP streaming (
A
173)
: FTP transfer (
A
176)
* You can also set
>
[
B
$
System Setup]
>
[LED]
>
[ (Ethernet)] to [Off] to disable the indicator.