Canon XF705, Instruction Manual

Page: 173 / 231

173
IP S treaming
IP S treaming
After connecting the camcorder to a network, you can stream the camcorder’s live video and audio* over IP to a
compatible IP video decoder** connected to the network. You can use IP streaming for live broadcasts or to
send a news flash report from a location with poor network connectivity.
While IP streaming is activated, internal recording to an SD card in the camcorder is disabled but recording to an
external device is possible.
* Only 2 channels. During 4-channel audio recording, you can select which two channels to stream over IP.
**This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders,
please visit your local Canon Web site.
Configuration of video s treamed over IP
*
>
[
3 !
Recording/Media Setup]
>
[Rec Format] setting. Available streaming signal options will vary depending on
the recording video configuration used.
IP S treaming S etting s
Before you can stream video over IP, you need to configure settings related to the transfer like the protocol and
port number to use. You can also select the configuration of the streamed video.
Camcorder Settings
1 Configure an Ethernet networ k connection (
A
159).
2 S elect [IP S treaming S etting s ].
>
[
!
Network Settings]
>
[IP Streaming Settings]
3 To s elect the video s treaming configuration, s elect [ S treaming Output S ignal].
• Select the desired option and then press SET.
4 To s elect the audio s treaming channel s , s elect [Audio Out Channel s ].
• Select the desired option and then press SET.
5 S elect [Protocol].
• Select the desired option and then press SET.
• If you selected [RTP+FEC], complete the error correction settings (
A
174).
Option s
[UDP]: This protocol prioritizes transfer speeds but does not guarantee the reliability/integrity of the data. Lost or
delayed IP packets are ignored.
[RTP]: Standard protocol for video/audio broadcasts over the Internet. Lost or delayed IP packets are ignored.
[RTP+FEC]: This setting uses the RTP protocol and adds a layer of FEC error correction so the receiving side* can
recover lost or delayed IP packets.
* A decoder compatible with FEC error correction is required.
Video format*
(compre ss ion)
Streaming configuration
Video
Audio
Bit rate Re s olution Frame rate
XF-HEVC
(H.265/HEVC compre ss ion)
16 Mbp s , 9 Mbp s 3840x2160
5 9 . 9 4P, 2 9 . 9 7P, 50.00P,
25.00P
MPEG-2 AAC,
256 Kbp s , 2 channel s
9 Mbp s , 4 Mbp s 1 9 20x1080
XF-AVC
(MPEG-4 AVC/H.264 compre ss ion)
9 Mbp s , 4 Mbp s 1 9 20x1080 5 9 . 9 4i, 50.00i
Operating modes: