Canon XF605, Instruction Manual

Page: 121 / 238

121
Cu s tom Picture S etting s
Resetting Custom Picture Files
1 Select a custom picture file (
A
119).
2 Select > [
/
Custom Picture] > [Edit
/
File] > [Reset].
3 Select a preset custom picture setting and then select [OK].
• The custom picture file will be reset to the selected values.
Look File s
You can register 3D LUT files (.cube format) created with Blackmagic Design’s DaVinci Resolve or other software
as Look Files in the custom picture file. Using a Look File allows you to adjust the video quality of the recorded
video. These adjustments apply also to proxy clips, photos, and screen/output terminals.
1 In s ert the S D card with the de s ired Loo k File (.cube format, located in the root directory of the S D
card) into the camera’ s S D card s lot B.
2 S elect a cu s tom picture file. (
A
119)
3 S elect > [
/
Cu s tom Picture] > [Edit
/
File] > [Gamma/Color S pace] > De s ired option.
4 S elect > [
/
Cu s tom Picture] > [Edit
/
File] > [Loo k File S etup] > [Regi s ter].
• The Look Files in the SD card will be displayed.
5 S elect the de s ired Loo k File.
6 S elect the [Gamma/Color S pace] s etting to u s e after the Loo k File i s applied.
7 S elect [OK] twice.
• The selected Look File will be loaded and registered to the custom picture file.
• The image quality adjustments set in the Look File will be applied, and will appear on the screen.
• When disabling the image quality adjustments set in the Look File, select > [
/
Custom Picture] >
[Edit
/
File] > [Look File] > [Off].
NOTES
About Look files
- The camera supports Look Files (.cube format) in 17 grid or 33 grid format created with Blackmagic
Design’s DaVinci Resolve or other software.
- Look Files with input ranges outside the 0 to 1 range in the header (“LUT_3D_INPUT_RANGE”) are not
supported.
- Look Files 2 MB and larger, as well as files with a name containing over 65 characters are not supported.
- Only the following characters can be used in the file name:
Numbers 0 to 9, upper/lower case letters a to z, underscore (_), hyphen (-), period (.) and a single byte
space.
• If the correct input/output gamma curve and color space conversion are not selected, video will not be output
correctly.
• A Look File cannot be used if the [Gamma/Color Space], [HLG Color] or [Over 100%] settings are changed
after registering it.
• When the gamma curve component of the [Gamma/Color Space] setting in the custom picture is set to either
[BT.709 Normal], [BT.709 Standard] or [BT.709 Wide DR], super-white (video signal above 100%) and super-
black (video signal below 0%) levels of brightness will be clipped. When the video signal contains super-white
brightness levels, select
> [
/
Custom Picture] > [Edit
/
File] > [Other Functions] > [Over 100%] >
[Press] and then activate the Look File to apply it to a signal compressed to 100%.