163
Menu Description
Men
u
Gu
ide
Men
u
De
scr
iption
Motion blur reduction
> [System settings] >
[Motion blur reduction]
Motion blur is blurring that occurs during video playback. Motion blur reduction can
make this blurring less noticeable.
Power management duration
Specify how much time must pass before the light source goes off or the projector enters
standby mode, depending on the [Power management mode] setting.
Option
Function
5 min. – 60 min.
After 30 seconds without an input signal when the projector is idle, the
projector starts displaying a countdown of the selected time.
Direct power on
You can turn on the projector by connecting the power cable without pressing the
POWER
button.
Option
Function
Off
The
POWER
button must be pressed to turn the projector on.
On
You can turn on the projector by connecting the power cable only.
Option
Function
Off
Motion blur reduction is not performed.
Weak
Reduce motion blur for fast-moving images. Note that images may
be slightly darker, and flickering may occur.
Strong
Reduce motion blur for images moving faster than with [Weak].
Note that images may be darker, and flickering may occur.
• If setting the projector to [Strong] or [Weak] produces distracting flickering, set it to [Off].
• [Motion blur reduction] is not available in [DICOM SIM] image mode. The menu is
grayed out.
• Motion blur reduction is not available when [Lamp mode] is set to [Power saver 2].
• If conditions that would start countdown are met while you are blanking projection,
blanking is canceled.
• Once countdown begins, audio output stops.
• Before enabling direct power on, be sure to set [Power management mode] to an
option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not
available.
• After turning off the projector, wait at least 5 minutes before turning it on again. It
may shorten the lamp life if you turn on the projector immediately after turning it off.
• The projector is also equipped with a Direct Power Off feature. No damage is caused
to the projector even if it is unplugged during projection to turn it off without pressing
the
POWER
button. However, setting adjustments made immediately before
unplugging the projector may not be stored.
