1-9
Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
1
1
D
etailed Settings
IPv6
(1) [IPv6]
Select [
Disable
] or [
Enable
] regarding the use of IPv6.
(2) [IPv6 Address]
If [
Enable
] is selected for IPv6, an automatically acquired address will be shown.
Note
z
For [
IP Address
], [
Subnet Mask
] and [
Default Gateway Address
], contact your network
administrator.
z
If any of the [
IP Address
], [
Subnet Mask
] and [
Default Gateway Address
] settings is wrong,
network access may be disabled. In this case, use VB Initial Setting Tool Ver. 5.0.1
("Perform Initial Setting of the Camera" in
Start Guide
) to set the address again.
z
If the [
IP Address
], [
Subnet Mask
], [
Default Gateway Address
], [
LAN Interface
] or
[
Maximum Packet Size
] setting is changed, the camera may become no longer accessible
from the active browser. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" ( P. 1-49). Also check the precautions in the
same section before changing each setting in "[
z
If [
Auto (DHCP)
] is selected as the address setting mode, the IP address may not be
assigned correctly in certain environments, such as when a router is present between the
DHCP server and this camera. In this case, assign a fixed IP address by selecting
[
Manual
].
z
If you are using IPv6, set 1280 or greater value under [
Maximum Packet Size
].
Tip
z
If you are using optical fiber or ADSL, you may be able to improve the sending efficiency by
slightly reducing the maximum packet size.
z
You can use the VB Initial Setting Tool to check the IP address assigned by [
Auto (DHCP)
].
Tip
In an environment where IPv6 cannot be used, the [
IPv6 Address
] field remains blank even
when [
Used
] is selected for IPv6.
COP
Y
