6
6
Installation
Installation
6-10
6-10
Installation > Checking The Operation > FAX Communication Test
Installation > Checking The Operation > FAX Communication Test
Checking The Operation
Type Settings
Select the country/region of the FAX Board in Service Mode (Level 1): FAX > TYPE > TYPE
This setting performs the parameter settings to match the communication specification of the
country/region.
1) Set the TYPE of country/region to install this machine, and then press OK.
• Service Mode (Level 1) > FAX > TYPE > TYPE
2) Turn OFF/ON the main power switch to enable this setting.
Basic Settings
NOTE:
When "System Manager Information Settings" is set, be sure to follow the direction of
user administrator in order to log in as an administrator.
In this section, make only minimum settings required for FAX communication.
1) Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 2]
> [Register User Telephone No.] > Enter FAX number > [OK]
2) Set the type of telephone line.
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 2]
> [Select Line Type] > Select the line type to connect > [OK]
3) Turn OFF/ON the main power switch after setting the user telephone numbers and the type
of telephone line.
FAX Communication Test
Perform communication test to check if FAX function works correctly.
1) Switch the control panel display to Fax display.
2) Select the sending line.
Press [Fax] > [Options] > [Select Line], select the added line, then press [OK] button.
3) Send and receive a test original between the equipment and a remote unit with which a
communication test can be performed and check if it can be sent and receive correctly.
3-1) Press [Status Monitor/Cancel] > [Send] > [Log] and select [Fax] from pull down
menu.
3-2) Press [Print List] > [Print the fax activity report?] > [Yes].
3-3) The number printed following colon(:) in "COMM. MODE" field on Fax Activity
Report TX/RX shows line type used for sending/receiving.
E.g. "ECM:2" => Line 2
