Canon PIXMA PRO-10, Manual

Page: 77 / 811

Home > Overview of the Printer > Maintenance > When Printing Becomes Faint or Colors Are Incorrect >
Aligning the Print Head
C102
Aligning the Print Head
If printed ruled lines are misaligned or print results are otherwise unsatisfactory, adjust the print head
position.
Note
You can also adjust the print head position using the computer.
Aligning the Print Head Position from Your Computer
If the remaining ink level is low, the print head alignment sheet will not be printed correctly. Replace
the ink tank whose ink is low.
Replacing an Ink Tank
You need to prepare: two sheets of A4 or Letter-sized plain paper
1.
Make sure that the power is turned on.
2.
Load two sheets of A4 or Letter-sized plain paper in the rear tray.
Important
The manual feed tray is not available for the print head alignment procedure. Be sure to load
paper in the rear tray.
3.
Open the paper output tray gently, then pull out the output tray extension.
Important
If the inner cover is open, close it.
4.
Hold down the RESUME/CANCEL button until the POWER lamp flashes white
four times, then release it immediately.
The print head alignment sheet will be printed and the print head position will be adjusted
automatically.
Do not perform any other operations until the printer completes the printing of the print head alignment
sheet. This takes about 5 to 6 minutes.
Note
If the automatic adjustment of the print head position has failed, the Alarm lamp flashes.
"Eleven flashes:" in Alarm Lamp Flashes Orange
If the print results are still not satisfactory after adjusting the print head position as described above,
adjust the print head position manually from the computer.
Aligning the Print Head Position Manually from Your Computer
Page top