Canon Paper Deck-V1, Service Manual

Page: 43 / 90

Chapter 3
3-1
3.1 Removing from the Host
Machine
3.1.1 Compartment
3.1.1.1 Removing the
Compartment
0009-2060
1) Place a stack of paper [3] (A: about 8 cm in height)
on the floor on which to place the deck [2], thus
preventing damage to the roll support plate [1].
F-3-1
2) Push the deck release grip to detach the deck from
its host machine. Then, push down the latch plate
[1] found at the rear left to open the compartment
[2].
F-3-2
3) Remove the screw [1] and the stopper plate [2], and
pull out the compartment [3] to the front.
F-3-3
4) Remove the 3 screws [1], and detach the right cover
[2].
F-3-4
5) Remove the screw [1] of the harness guide,
disconnect the connector [2], and remove the 3 screws
[4] each on the right and left of the compartment rail
[3]; then, lift the compartment [5] slightly to detach it
toward the front.
6) Place the compartment [5] on the base you prepared
in step 1)
[2]
[3]
[3]
[1]
A
(rear)
[2]
[1]
(left rear of the
compartment)
[2]
[1]
[3]
[2]
[1]