20
20
Adjustment > Adjusting the Position of the Front Cover
Adjustment > Adjusting the Position of the Front Cover
Adjustment
Adjusting the Left Edge Margin
■
For iR ADVANCE 4045/4051 series
1) Check to make sure that the 2 adjusters of the pedestal of the host machine are in contact
with the floor.
2) Turn on the host machine.
3) Check to see that the paper deck is used as the source of paper and the operation is
correct.
4) Make copies/prints of the test image, and check the output images to see that the left edge
margin of the paper deck is the standard: 2.5 +/- 1.5 mm. Otherwise, perform the following:
<Left Edge Margin Adjustment of Paper Deck>
4-1) Set the host machine to the service mode (LEVEL 2) and select “DK-ADJ-Y”.
LEVEL2/COPIER>ADJUST>MISC>DK-ADJ-Y
4-2) According to the test image, change the input value.
As the value is changed by 1, the left edge margin is increased or decreased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
4-3) After the completion of the adjustment, exit the service mode.
■
For iR ADVANCE 5051 series
1) Check to make sure that the 2 adjusters of the pedestal of the host machine are in contact
with the floor.
2) Turn on the host machine.
3) Check to see that the paper deck is used as the source of paper and the operation is
correct.
4) Make copies/prints of the test image, and check the output images to see that the left edge
margin of the paper deck is the standard: 2.5 +/- 1.5 mm. Otherwise, perform the following:
<Left Edge Margin Adjustment of Paper Deck>
4-1) Set the host machine to the service mode and select “ADJ-DK”.
LEVEL1/COPIER>ADJUST>FEED-ADJ>ADJ-DK
4-2) According to the test image, change the input value.
As the value is changed by 1, the left edge margin is increased or decreased by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
4-3) After the completion of the adjustment, exit the service mode.
Adjusting the Position of the Front Cover
1) Be sure that the front cover is positioned so that the gap between the front cover and the
upper front cover is the standard: 3 +/- 1 mm. Otherwise, adjust the position of the front
cover with the 4 screws tightening the front cover.
3±1mm
F-1-52
