Operator´s Manual
0073-095-418-EN Rev. 5.1
OMNERA®
2020-09-25
Page 81
4.3 Movement Short-cut Zones
A short-cut movement is defined as, when the OTC moves directly to the intended position,
without first moving up into the transport interval zone.
Movement short-cut zones are defined both for the Table and the Wallstand, as rectangular
cubes.
To perform a short-cut movement, the following conditions must be fulfilled;
• The System shall be positioned above the Table, or at the specified short-cut zone in front
of the Wallstand.
• At least one of the OTC corners must be inside the short-cut zone at the start of the
movement.
Outside these short-cut zones, the OTC will first move in Z direction, to the transport inter-
val zone, before moving to position.
Summary of Contents for OMNERA 400A
Page 1: ...Technical Publication Operator s Manual 0073 095 418 EN Rev 5 1 ...
Page 140: ...OMNERA 0073 095 418 EN Rev 5 1 Operator s Manual Page 134 2020 09 25 Waste Disposal ...
Page 150: ...OMNERA 0073 095 418 EN Rev 5 1 Operator s Manual Page 144 2020 09 25 Appendix A Glossary ...
Page 156: ......
