Canon oce 31x5e, Daily Maintenance

Page: 63 / 137

Extended copy jobs 63
You will find that certain heavy materials do not move smoothly into the
finisher. In these cases, you will need to change the output location to the upper
tray. All the copied output will then be delivered into the upper output tray, but
automatic stapling will no longer possible.
[35] Feed direction of pre-printed and punched copy material in the paper trays
Attention:
Do not use pre-copied paper because this may pollute the
machine.
▼
Copying onto special material
1
Open the paper compartment door. Tray 4 will move down automatically as
soon as the door is opened.
Note:
If the key operator has locked the paper compartment door you will
have to call the key operator in order to load special paper.
2
Place the special copy material in the required tray as described in ‘Loading
paper’ on page 76.
Note:
Material with a specific page orientation must be loaded into the
paper trays as shown in figure 35.
3
Close the paper compartment door.
The bottom tray will move up automatically.
4
Place your A4 originals in the automatic feeder
5
Open the ‘Paper’ section and select the ‘Paper input’ settings.
6
Press the ‘Source’ function button to activate the ‘Tray’ option and select the
corresponding paper tray in which you loaded the special copying material.
✱
✱
Feed direction of copy
material in tray 4 long-edge feed originals
✱
✱
short-edge feed originals Feed direction of copy material in trays 1, 2 or 3
special feeder/
glass platen
✱
= Top of page
= Feed direction
Feed direction of copy
material in trays 1, 2 or 3
✱