Setting Preferences and Scanning with ScanGear MF
3-20
S
c
ann
ing
3
4
Select the destination of the scanned image.
You can select from [Print (300 dpi)], [Image display (150 dpi)], or [OCR (300 dpi)],
depending on the document type you select in step 2.
For details on this setting, see "Determining Resolution," on p. 3-41.
5
Select the output size of the scanned image depending on the
destination you selected in step 4.
If you select [Add/Delete], you can add or delete the custom output size. For details
on setting, see "Add/Delete the Output Size," on p. 3-20.
Click
to switch the orientation of the output size (landscape or portrait).
6
Click [Scan].
Scanning starts.
NOTE
If white lines appear on one edge of the scanned image, check that the document is
correctly placed on the platen glass. A document should be placed approximately 0.12
inches from the front edge (i.e., the edge closest to the control panel) of the platen glass.
Add/Delete the Output Size
Selecting [Add/Delete] for the [Output Size] in the [Simple Mode] tab sheet opens
the [Add/Delete the Output Size] dialog box. In this dialog box, you can add or
delete the custom output size.
[Output Size
Name]
Specifies the output size name you want to register.
[Width]
Specifies the width of the output size.
