![background image](http://html.mh-extra.com/html/canon/lv-s300/lv-s300_user-manual_62548064.webp)
64
13. Restart the projector.
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14. After the startup logo, open the On-Screen Display (OSD)
menu. Go to the
SYSTEM SETUP: Advanced
>
Lamp
Settings
menu. Press
OK/IMAGE
. The
Lamp Settings
page is displayed. Press to highlight
Reset lamp timer
and press
OK/IMAGE
. A warning message is displayed
asking if you want to reset the lamp timer. Highlight
Reset
and press
OK/IMAGE
. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced as this could cause damage.
10. Place the lamp protection film supplied with the new lamp
on the lamp compartment.
11. As shown in the figure, replace the lamp cover on the
projector.
12. Tighten the screws that secure the lamp cover.
•
Loose screw may cause a bad connection, which could
result in malfunction.
•
Do not over tighten the screws.
2
1
Notice
Reset Lamp Time ?
Reset
Cancel