![Canon Laser Shot LBP-1120 Service Manual Download Page 83](http://html.mh-extra.com/html/canon/laser-shot-lbp-1120/laser-shot-lbp-1120_service-manual_2553154083.webp)
4 - 7
CHAPTER 4
II. IMAGE DEFECTS TROUBLESHOOTING
Perform troubleshooting according to the malfunction diagnosis flowchart (Figure 4-1-1). If an “image defect” is
found, the defective part must be located and rectified by the following procedures.
Table 4-2-1
II-1.
Light
<Possible Causes>
1.
Improperly adjusted image density.
Action:
Adjust the image density by operating the external device.
2.
Open the cartridge cover and remove the EP-22 cartridge while printing. Open the drum protective shield of the
cartridge and check the toner image on the photosensitive drum surface. If the toner image has not been transferred
onto the paper properly, go to step 3). If the toner image on the drum is faint, go to step 6).
Do not open the drum protective shield for more than 10 seconds.
3.
Deformation or deterioration of the transfer charging roller.
Action:
Replace the transfer charging roller.
4.
Poor contact in the transfer charging roller contact on the engine controller PCB and the transfer charging roller
shaft contact.
Action:
Clean the contacts if dirty. If the problem still remains after cleaning, or parts are deformed or
damaged, replace them.
5.
Defective laser/scanner unit.
Action:
Replace the laser/scanner unit.
6.
Defective engine controller PCB.
Action:
Replace the engine controller PCB.
2-1
Light
2-2
Dark
2-3
Completely blank
2-4
All black
2- 5
Dirt on back of paper
2-6
Dirt
2-7
Black vertical lines
2-8
White vertical lines
2- 9
Black horizontal lines
2-1 0 White horizontal lines
2-11 Blank spots
2-12 Poor fixing
2-13 Image distortion
2-14 Faulty registration
Defects
Additional explanation
Output very light image.
Output very dark image.
Output no image.
Output all black paper.
Output dirt on the back of the paper.
Output dirt on surface of the paper.
Output black vertical lines.
Output white vertical lines.
Output black horizontal lines.
Output white horizental lines.
Output image with blank spots.
Output image with poorly fixed toner.
Output distored image.
Gap between the leading edges of the paper and the image.
Image defects
Summary of Contents for Laser Shot LBP-1120
Page 4: ...PREFACE P 2 ...
Page 54: ...2 35 CHAPTER 2 Figure 2 6 1 4 1 3 2 J1 2 1 20 19 J2 IC2 IC1 IC3 IC4 ...
Page 107: ...APPENDIX A 2 ...