Canon iR C6800 Series, Portable Manual

Page: 92 / 456

Chapter 2
2-38
F-2-65
See the following sample. The cell with a check
mark [1] indicates the present drum phase location. In
this case, the marking [3] is located in relation to the
protrusion [2] of the drum fixing member with its left
at ".." and right at "..." .
F-2-66
4. Be sure to fit the drum fixing member [1] to the
drum flange [2] in correct relation to the phase
location indicated on the drum phase label.
F-2-67
2.5.15 After Repacking the
ITB
0004-4225
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
When you have replaced the ITB belt, be sure to
execute the following service mode item.
Be sure that you execute service mode immediately
after the control panel screen has appeared after
turning on the main switch. :
COPIER>FUNCTION>MISC-P>ITR-ROT.
2.5.16
After Replacing the
Primary Transfer Roller
0004-4230
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
As the machine is used more and more, the shavings
from the primary transfer roller can start to collect on
the rollers behind the belt.
When you have replaced the primary transfer roller,
be sure to clean the 6 rollers [1] and the scraper [2]
indicated below.
The idler roller (indicated by an arrow) is designed
for mounting after fitting the intermediate transfer
belt. Although the figure shows the roller, it is only for
reference purposes, and the roller is not in its indicated
1. COPIER
> TEST
> PG > TYPE
= 16
2. COPIER
> FUNCTION
> INST
ALL > AINR-OFF
= 1
3.
4. COPIER
> FUNCTION
> MISC-P
> DR-P-ADJ
= OK
5. COPIER
> FUNCTION
> MISC-P
> P-PRINT
= OK
6. PASCAL
1
2
3
4
1
2
2
3
3
4
4
1
[1]
1 2
3
4
1. COPIER > TEST > PG > TYPE = 16
2. COPIER > FUNCTION > INSTALL > AINR-OFF = 1
3.
4. COPIER > FUNCTION > MISC-P > DR-P-ADJ = OK
5. COPIER > FUNCTION > MISC-P > P-PRINT = OK
6. PASCAL
1 2
2 3
3 4
4 1
1
2
3 4
[2]
[3]
[1]
[1]
[2]
[2]