Canon iPR C7010VP Series, Installation Manual

Page: 96 / 157

Chapter 2
2-51
- Front side
- 1 E-ring [2]
- 1 bearing [3]
- Rear side
- 1 E-ring [4]
- 1 pulley [5]
- 2 dowel pins [6]
F-2-226
When detaching the duplexing feed roller 3-2
11) Move the duplexing feed roller 3-2 [1] in the direction of the arrow and
detach it.
- 1 screw [2]
- 1 bushing (w/leaf spring) [3]
- 1 E-ring [4]
- 1 bearing [5]
- 1 belt [6]
F-2-227
12) Remove the following parts from the duplexing feed roller 1-1 [1].
- Front side
- 1 E-ring [2]
- 1 bearing [3]
- Rear side
- 1 E-ring [4]
- 1 pulley [5]
- 2 dowel pins [6]
F-2-228
2.1.7.2 Main Station Duplexing Feed Unit 2 (9 million
prints)
0026-4718 imagePRESS C6010 / im agePRESS C7010VP / imagePRESS C60 10VP /
imagePRESS C7010VP FS / image PRESS C7010VP PSU / imagePRE SS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Duplexing feed roller 2-1 (FC9-9478)
- Duplexing feed roller 2-2 (FC9-9477)
2. Before the replacement
1) Remove the Main Station Duplex Feed Unit 2. R efer to "Chapter 8 Re-
moving the Main Station Duplex Feed Unit 2" in the Service Manual.
3. Replacement procedure
3-1. Removing the duplexing feed roller 2-1/2-2
1) Detach the guide plate (front) [1].
- 2 screws [2]
F-2-229
2) Detach the motor unit [1].
- 1 belt [2]
- 1 connector [3]
- 3 screws [4]
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
[2]
[3]
[5]
[6]
[4]
[1]
[3]
[4]
[5]
[2]
[1]
[6]
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
CAUTION:
Be careful not to lose the bushing [1] not being secured.
[2]
[3]
[1]
[5]
[6]
[4]
[2] [1]