Canon Inner 2 Way Tray-E1, Service Manual

Page: 26 / 42

Chapter 3
3-2
F-3-7
3.1.1.9 Removing the rear cover
0011-3308
1) Remove the RS tightening screw (M3 x 8) [1], and then detach the rear
cover [2].
F-3-8
3.1.1.10 Removing the inner 2-way tray
0010-7170
1) Disconnect the connector (J201) [1] of the full sensor from the DC con-
troller PCB.
F-3-9
2) Remove the inner 2-way tray harness from the guide, and then disconnect
the connector (J51) [1] from the optional power supply PCB.
F-3-10
3) Remove the inner 2-way tray harness from the guide, and then disconnect
the connector (J204) [1] from the DC controller PCB.
F-3-11
4) Remove the inner 2-way tray harness from the two wire saddles [1].
F-3-12
5) Turn down the fusing pressure release lever.
F-3-13
6) Remove the two TP binding screws (M3 x 6) [1], and then remove the in-
ner 2-way tray [2].
[2] [1]
[2] [1]
[1]
[1]
[1]
[1]
[1]