Canon imageRUNNER C3100 N Printer, Printer Manual

Page: 44 / 158

Settings Menu
2-14
2
Pr
inter Settings Men
u
■
Offset X/Offset Y
-2.00 to +2.00 inch (in increments of 0.01 inch); 0.0 * inch
This setting sets the offset position in inches. The settings can be set between
-2.00" (-50.0 mm) and +2.00" (+50.0 mm) in increments of 0.01" (0.5 mm).
The print position is adjusted in the vertical or horizontal direction to the value
specified in the setting value.
You can increase or decrease the setting in increments of 0.01" (0.5 mm) to adjust
the print position, as described below.
Offset X: Increasing the setting value moves the image in the rightward X
direction on the paper. Decreasing the setting value moves the image in the
leftward X direction on the paper.
Offset Y: Increasing the setting value moves the image in the downward Y
direction on the paper. Decreasing the setting value moves the image in the
upward Y direction on the paper.
IMPORTANT
Please note that if the print position is adjusted to place print data outside the valid
print area, the portion outside the valid print area is not printed.
NOTE
•
If this setting is used in combination with the Margin setting, the values of the two
settings are added together.
•
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
pressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holding
down either [ ] or [ ] continuously speeds up the value alteration.
DEF ABC
DEF
X X
Y Y
Adjust using
X/Y-Adjustment
Area adjusted using Y-Adjustment
[+]
Area adjusted using
X-Adjustment
[+]
Front Back Front Back
ABC
Part of the
original margin