4
4
4-154
4-154
Parts Replacement and Cleaning > Image Formation System > Removing the Toner Container Front Inner Cover > Procedure
Parts Replacement and Cleaning > Image Formation System > Removing the Toner Container Front Inner Cover > Procedure
CAUTION:
Be sure to fit the 2 holes of the Main Drive Unit to the shafts of the host machine, and fit
the 4 couplings into the holes of the host machine when installing.
At this time, pulling out the Process Unit will make installation easier.
Pin
Hole
Hole
Hole
Coupling
Pin
F-4-255
Removing the Toner Container Front Inner Cover
■
Preparations
1) Open the Toner Replacement Cover.
2) Execute the service mode and release the lock of Toner Container.
NOTE:
To release the lock of Toner Container manually, refer to the step 1) to 4) in “Removing
the Toner Container manually”. At that time, do not pull out the toner container.
3) Turn OFF the power before closing the Small Cover and the Toner Replacement Cover.
4) Close the 4 Small Covers and the Toner Replacement Cover. (Same in manual operation)
5) Open the Front Cover, the Right Lower Cover and Right Upper Cover.(Refer to page 4-104)
6) Remove the ITB Unit.(Refer to page 4-105)
7) Remove the Process Unit.(Refer to page 4-132)
■
Procedure
1) Remove the Front Right Cover.
• 1 rubber cap
• 1 screw (remove)
• 1 screw (loosen)
Front right cover
Rubber cap
Loosen
F-4-256