4
4
4-67
4-67
Disassembly/Assembly■>■Image■Formation■System■>■Removing■the■Primary■Transfer■Roller■(Y/M/C/BK)■>■Procedure
Disassembly/Assembly■>■Image■Formation■System■>■Removing■the■Primary■Transfer■Roller■(Y/M/C/BK)■>■Procedure
Points■to■Note■at■Installation:■
Install■the■ITB■by■inserting■paper■between■the■belt■and■the■frame■as■shown■in■the■figure■
below.
•■ ■A■new■ITB■comes■with■dedicated■paper.
Be■sure■that■the■rib■of■the■ITB■is■not■placed■on■the■Tension■Roller.
F-4-135
NOTE:
•■ Parts■Counter■:■COPIER■>■COUNTER■>■DRBL-1■>■TR-BLT
•■ It■is■also■cleared■at■the■same■time■when■TR-UNIT■is■cleared.
•■ After■installation,■execute■[Auto■Adjust■Gradation>■Full■Adjust],■[Auto■Correct■Color■
Mismatch].
Removing■the■Primary■Transfer■Roller■(Y/M/C/BK)
■
■
Preparation
1)■Remove■the■ITB■Unit.(Refer■to■page■4-61)
2)■Remove■the■ITB■Cleaning■Blade.(Refer■to■page■4-63)
3)■Remove■the■ITB.(Refer■to■page■4-64)
■
■
Procedure
1)■Remove■the■ITB■Cleaning■Blade■[1],■and■lay■down■the■ITB■Unit■such■that■the■Primary■
Transfer■Roller■is■visible.
[1]
2)■Remove■the■Primary■Transfer■Roller■Retainer■Member■[1].
[1]
F-4-136
F-4-137
