13
13
Margin Adjustment (2nd side)
1) Execute duplex printing from the Cassette 3, and check that the left edge margin is within 2.5
+/- 2.0mm.
Feed direction
of paper
L1
image
2) If the margin is not within the range, change the left edge margin adjustment value for the
2nd side of the Cassette 3.
• As the value of COPIER > ADJUST > FEED-ADJ > ADJ-C3RE in service mode is
incremented by 1, the left edge margin is decreased by 0.1mm.
3) Enter the value same as the left edge margin adjustment value for the 2nd side of the
Cassette 3 to the side registration adjustment value for the 2nd side of the Cassette 4.
• Service Mode > COPIER > ADJUST > FEED-ADJ > ADJ-C4RE
4) Turn OFF and then ON the main power switch to enable the setting value.
5) Execute duplex printing from the Cassette 4, and check that the left edge margin is within 2.5
+/- 2.0mm.
6) If the margin is not within the range, change the left edge margin adjustment value for the
2nd side of the Cassette 4.
• As the value of COPIER > ADJUST > FEED-ADJ > ADJ-C4RE in service mode is
incremented by 1, the left edge margin is decreased by 0.1mm.
7) Write down the new adjustment value in the service label.
• ADJ-C3RE
• ADJ-C4RE
8) Get out from service mode.
F-1-35
[Models other than imageRUNNER ADVANCE C2030/
C2020 Series]
Auto Adjust Gradation
1) Clean the Copyboard Glass surface of the host machine.
2) Set A3, A4, 11x17, or LTR size papers in a cassette.
3) Select [Settings/Registration] > [Adjustment /Maintenance] > [Adjust Image Quality] > [Auto
Adjust Gradation].
4) Select the source of paper for test print, and press [OK].
5) From this point on, follow the instruction on UI.
Checking the Print Image
1) Place a document on the document glass, copy it by feeding paper from the cassette or
manual-feed tray, and then check the resultant print image.
• Check that no abnormal noise is heard.
• Check the image quality at respective magnifications.
• Check that the document is copied normally on the specified number of sheets.
