Canon imageRUNNER 1025, Basic Operation Manual

Page: 146 / 327

Fax (imageRUNNER 1025iF Only)
5-23
Specifying Destinations
8
Press [Start].
If the <ORIGINAL SIZE> message appears, press
[
] or [ ] to select the original size, then
press [Start] for each original. When scanning
is complete, press [OK] to start sending.
When <TIME OUT> is set to <ON> in <TX
SETTINGS> in <FAX SETTINGS> in <TX/RX
SETTINGS>, and if you have specifi ed the
destination by any other method than using
– [numeric keys], the machine starts
scanning automatically without pressing
[Start], after the preset time for this setting is
elapsed.
You can also adjust the following scan settings
as necessary, using the keys on the operation
panel, after specifying the destination in step 7.
Image Qaulity: See “Selecting Image Quality,”
on p. 5-29.
Density: See “Adjusting Density,” on p. 5-30.
2-Sided: See “2-Sided Originals,” on p. 5-31.
–
–
•
•
•
Using the One-Touch Keys Using the One-Touch Keys
You can specify up to 23 destinations in the one-touch Keys.
To use this feature, you must fi rst register destinations in the one-touch Keys. (See “Storing/Editing One-Touch Keys” on p. 3-3.)
A maximum of 201 destinations can be specifi ed at the same time. (Out of the 200 destinations, a number or address can be specifi ed
with the numeric keys.) If you specify a group, which is made up of several destinations, each destination in the group is counted as a
separate address. –
–
1
Place the original on the platen glass or
load it in the ADF.
2
Press [SEND].
3
Press the desired one-touch key (01 to
23).
■ If you enter a wrong key:
Press [Clear] and try again.
■
If you specify an I-fax address:
You can enter the optional settings by
pressing [OK]. (See “Send Settings,” on p. 5-
43.)
[ 0 1 ] J o h n
= 0 1 2 X X X X X X X