End of paper feed.
Cause
Corrective Action
You are pressing the
▲
button on the Control Panel and trying to rewind the roll to the edge.
Release the
▲
button.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.
Release the
▲
button.
Rel lever is in wrong position.
Cause
Corrective Action
The Release Lever is up.
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Rewinding error.
Cause
Corrective Action
There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
Remove the foreign object near the sensor.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
tected.
Wipe the sensor with a dry cloth to clean it.
The roll is out of range of detection by the Media Take-up Unit sen-
sor.
Reload the roll.
The Media Take-up Unit sensor is damaged.
Contact your Canon dealer for assistance.
A paper jam has occurred and the roll cannot be rewound.
Remove the paper from the Media Take-up Unit.
Press the
OK
button to clear the error.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set
Skip Take-Up Err
to
On
. However, note that this error may cause paper jams and affect the printing
quality.
Media take-up unit ready.
Cause
Corrective Action
The
Take-up Reel
setting in the printer
Set./Adj.
Menu
was changed from
Enable
to
Disable
, but a
print job was received before the roll was re-
moved.
Press
▲
or
▼
to select
Stop Printing
, and then press the
OK
button to stop printing.
The mode switches from take-up mode to regular mode after you
change the
Take-up Reel
setting in the
Set./Adj. Menu
from
En-
able
to
Disable
and lift the Release Lever to remove a roll, or af-
ter you execute
Paper Cutting
.
Press
▲
or
▼
to select
, and then press the
OK
button to
resume printing.
Error Message
>
Messages regarding paper
>
iPF8300
End of paper feed.
13
1091
