![background image](http://html2.mh-extra.com/html/canon/imageformula-dr-g2140/imageformula-dr-g2140_user-manual_4238721068.webp)
68
Separation Force
If double feeding or a paper jam occurs, consider changing the
Separation Mode.
High Separation Mode
: Use when high friction between fed sheets
makes their separation difficult.
Normal
: Use this setting normally.
Thin Paper Mode
: Use when feeding fine documents.
CAUTION
In [High Separation Mode], the separation force can be strong
enough to damage some documents. In that case, use the [Normal]
or [Thin Paper Mode].
Manual Feed
Configures the continuous manual feeding mode. Select from the
following menu settings.
On/Off
This mode disables automatic feeding by the Pickup Roller, so that the
loaded document stack must be fed by hand onesheet at a time by the
operator.
"Continuous manual feeding mode" (See p. 46)
On
: The Pickup Roller is disabled.
Off
: Documents are fed by the Pickup Roller.
Roller Rotating Time
Set the time (0, 30, 60, 180, or 300 seconds) that the Feed Roller will
continue to rotate after feeding in a stack of documents.
Staple Detection
Set the Staple Detection sensitivity level.
High Sensitivity
: High Staple Detection sensitivity.
Normal
: Normal Staple Detection sensitivity.
Low Sensitivity
: Low Staple Detection sensitivity.
Long Document
Configures the Long Document Mode. Select from the following menu
settings.
Max Document Length
Sets the maximum length of documents to be scanned.
Document Scanning" (See p. 51)
Long Document (5588 mm)
: Documents up to 5,588 mm long (220")
are automatically detected for scanning.
Long Document (3000mm)
: Documents up to 3,000mm long
(118.11") are automatically detected for scanning.
Long Document (1000mm)
: Documents up to 1,000mm long
(39.37") are automatically detected for scanning.
Default (432 mm)
: Documents up to 432 mm long (17") can be
scanned.
Hint
• Feeding a document longer than the maximum automatically
detectable pagelength causes a paper jam, and transport stops.
• The [Long Document (5588 mm)] setting is not available in the
DR-G2090.