Canon i-SENSYS MF6180dw, Manual

Page: 885 / 1040

0FR4-0LS
Check the following sections.
Remote UI is not displayed.
The printer port name is not displayed in [Print to the following port(s)]
The machine automatically connects to the wrong destination via the dial-up connection (when using a dial-up router)
Remote UI is not displayed.
Check network connection.
"Checking Network Connection (Wired LAN)"
Check whether the IP address of the machine matches the subnetwork address of the computer's IP address.
The machine's default settings have <DHCP> and <Auto IP> enabled, so it obtains an IP address automatically.
If the subnetwork addresses of the machine and the computer do not match, set the IP address of each device manually
to have the same subnetwork address.
"Setting the IP Address"
You can check IP address of the machine:
"Checking IP Address Settings"
How to recognize general network addresses
When the subnet mask is set as "255.255.255.0", it is the same as the value which the rightmost IP address separated
by a period is replaced with a "0".
Ex.:
IP Address: 192.168.127.123
Subnet Mask: 255.255.255.0
Subnetwork address of the above example: 192.168.127.0
You cannot configure connection beyond routers. Use it within the same segment (an environment which does
not go beyond a router).
Make sure that <IPv4 Address Filter>, <IPv6 Address Filter> or <MAC Address Filter> is not specified for the machine.
If it is specified, change the setting so that IP address and MAC address of your computer can be permitted.
"Restricting Sending/Receiving to/from Specific IP Addresses"
"Restricting Sending/Receiving to/from Specific MAC Addresses"
Check to see if <SNMPv1 Settings> or <SNMPv3 Settings> is set to <Off> for the machine.
You may not be able to specify and browse each item of the machine from utility software that uses the SNMP protocol
to obtain the information. Change <SNMPv1 Settings> or <SNMPv3 Settings> to <On>.
You can set <On> to both <SNMPv1 Settings> and <SNMPv3 Settings>.
When <SNMPv1 Settings> is set to <On>, the machine cannot be recognized when accessed from the utility
software with a community name different from the machine setting. If it cannot be recognized, check your
community name.
"Monitoring/Controlling Devices by SNMP (SNMP Setting)"
Make sure that <Dedicated Port Settings> is <On>.
"Setting the Dedicated Port"
The printer port name is not displayed in [Print to the following port(s)]
Make sure that the correct printer driver is installed to your computer.
Wired LAN Troubles
㻤㻤㻡㻌㻛㻌㻥㻢㻠