Canon HD XS HJ24ex7.5B, Operation Manual

Page: 43 / 110

E11
1. Setting the framing memory position
Zoom (and focus) to the position that you want to store,
while holding this
z oom (and z oom focus) position, press
the “Fr1P” switch while holding down the MEMO switch.
This framing memory position is different from the
shuttle memory position (Refer to “5-1-5. Shuttle-Shot
Function”).The stored
z oom position remains in the
memory, even after the power is turned off.
2. Moving to the framing memory position
Once the “ Fr1P ” switch is pressed, the z oom starts to move toward the framing memory position at the preset
speed and stops at the framing memory position. When the z oom reaches to the framing memory position, it
stops and stays there.
3. Canceling the movement to the framing memory position or switching to other z oom operation
During movement to the framing memory position, the movement can be canceled and/or switched to other
z oom operation by any of the following operations.
[Zoom Framing Preset]
• Press the “Fr1P” switch again.
• Perform z oom operation with the z oom rocker see-
saw.
• Perform z oom operation with the “Shtl”
switch.
Zoom Rocker Seesaw
"Fr1P" Switch
"MEMO"
Switch
5-1-8 Clutchless Zoom （
“ -C S ” LENS only ）
The “ -C S ” lens clutchless incorporates a clutchless z oom mechanism.
Owing to the clutchless z oom mechanism, you are no longer required to operate the clutch when switching between
the servo z oom and manual z oom. This mechanism allows you to use a slow steady servo z oom technique in the
MANUAL mode.
Set the z oom operation change-over knob to the SERVO position
to activate the clutchless z oom mechanism.
Zoom operation
change-over knob
Clutchless
z oom
mechanism
Operation
SERVO ON
Setting used when both servo and manual operations are needed
Without operating a clutch, you can switch between the servo
z oom and manual z oom.
MANU. OFF Set to MANU. when using only the manual z oom.
ZOOM FOCUS
Zoom Operation Change-over Knob
REMOTE1 REMOTE2/
VIRTUAL REMOTE3
MANU. SERVO MANU. SERVO
[Focus Framing Preset]
[Zoom, Focus Framing Preset]
• Operate a connected focus demand. Movement to
the memory position stops, and movement to the
operating position of the focus demand takes place.
5 OPERATION
NOTE
The lens may be damaged if manual zoom operation is
performed during the servo zoom operation.