Chapter 5
5-10
5.3.11
E584
0009-2692
T-5-14
5.3.12
Temporary Functional Limit
0009-2693
1. Overview
The machine has a feature to temporarily enter the limited operation mode to perform only paper delivery, when an
error is encountered. The machine can continue to operate in this limited mode until the error is removed.
In the limited operation mode, stapling, alignment, and punching (only applicable when equipped with optional
puncher unit) are not performed, while the inlet sensor (PI103), escape tray path sensor (PI118), and feed path sensor
(PI104) remain enabled to detect any jam.
2. Operation
1) When the host machine has started up, use service mode or user mode as follows:
1-a) Service Mode
Set '1' for the following: SORTER>OPTION>MD-SPRTN.
1-b) User Mode
Press [limit function mode]; when a Confirmation screen has appeared, press [yes].
3) Turn off and then on the main power switch of the host machine.
3. Communication with the Host Machine
1) When the main power switch is turned on, the DC controller PCB will communicate to the main controller PCB
that a functional limit has been imposed. The control panel will indicate that a functional limit has been imposed
on the finisher.
2) The DC controller PCB backs up information on the functional limit.
3) Each time pickup occurs, the main controller PCB communicates the presence of a functional limit to the DC
controller PCB.
4) The DC controller PCB executes control only on delivery operation.
Code
Detail
Error
Description
Detection timing
E584
8001
Stack ejection
motor (M102)/
Shutter open/
close clutch
(CL101)/
Shutter home
position sensor
(PI113)/Stack
ejection lower
roller clutch
(CL102)
The stapler does not leave the shutter
home position when the stack ejection
motor has been driven for 3 seconds.
0002
The stapler does not return to the shutter
home position when the stack ejection
motor has been driven for 3 seconds.
Summary of Contents for Finisher-T1
