Canon Finisher-T1, Portable Manual

Page: 24 / 66

Chapter 2
2-4
make sure that the paper will be stacked correctly.
- After this mode items has been enabled, changes in
conditions (e.g., the use of paper with little upward
curl or delivery of paper with downward curl) can
prevent the machine from correctly stacking paper. In
this light, it is very important to check the type of
paper the user most often uses before enabling this
mode item.
2.1.6 Offset Stack Mode
0009-4798
a. Outline
Depending on the paper condition, paper can curl and
the machine can fail to deliver/stack it properly in the
small size offset mode.
If this is the case,
1) Turn over the stack of paper in the source cassette.
If doing so has caused the paper to curl much more
than before, turn back over the stack. If the machine
still fails to stack paper due to large curl, try enabling
the offset stack mode.
b. Enabling the Offset Stack Mode
1) Turn off the host machine.
2) Set the bits of SW104 on the finisher controller
PCB as follows:
F-2-11
3) Turn on the host machine.
- When this mode has been enabled, the stack delivery
is performed without buffering and the speed of the
stack delivery roller is changed to an appropriate one
to ensure proper stacking.
- If paper with little curl is delivered after this mode
has been enabled, the change in condition can cause
improper stacking. In the light of this, be sure to check
the type of paper that is most frequently used by the
user before enabling this mode.
ON
1 2 3 4 5 6 7 8