Canon Finisher-R1, Service Manual

Page: 126 / 177

Chapter 4
4-51
F-4-176
4.4.2.8 Removing the Stapler
0004-4707
1) Pull out the stapler, remove screw [1], and remove
the PCB cover [2].
F-4-177
2) Release the claw [3] and remove the PCB [4].
3) Disconnect three connectors [5].
4) Remove screw [6] and remove the stapler together
with the stapler base [7].
When removing, be careful not to damage the flag
[8].
F-4-178
5) Turn the stapler over, disconnect two connectors
[9], remove two screws [10], and remove the stapler
from the stapler base.
F-4-179
4.4.2.9
Removing the
Processing Tray
0004-4708
1) Unfasten four snap fasteners [1] and remove the
sensor flag [3] from the stack delivery roller [2].
Hold the snap fastener at the base when
unfastening because the sensor flag arm can break
easily. When fastening, insert the boss of the sensor
flag snap fastener in the hole on the processing tray
side.
[1]
[1]
[1]
[2]