5
5
5-12
5-12
Adjustments > Adjustment Method > Height Adjustment
Adjustments > Adjustment Method > Height Adjustment
Tilt Adjustment
CAUTION:
Execute this adjustment after releasing the angle restriction (opening angle at 90 deg).
1) Loosen the fixing nut on the back of the left hinge.
2) Rotate the hexagon socket bolt and move the fixing material to the marking line.
To move it forward: rotate it clockwise
To move it backward: rotate it counter clockwise
Fixing material Marking line
Hexagon socket bolt Fixing nut
3) Tighten the fixing nut after adjustment.
F-5-7
Height Adjustment
1. Check the height.
1) Close the DADF.
2) Check that the 2 height adjustment rolls on the front/rear left come contact with the stream
reading glass.
Note:
Turning ON the LED helps the check operation.
(Lv.1) COPIER > FUNCTION > MISC-R > SCANLAMP
Stream reading glass
Height adjustment roll
Height adjustment roll
3) If not, execute the height adjustment.
If you cannot check it visually, check it by the following method.
F-5-8
Summary of Contents for F-1
Page 14: ...2 2 Technology Technology Basic configuration Controls Service Work ...
Page 72: ...3 3 Periodic Servicing Periodic Servicing Periodic Servicing List ...
Page 135: ...5 5 Adjustments Adjustments Overview Adjustment Method ...
Page 175: ...Appendix Service Tools General Circuit Diagram ...
