E10
5. Details of Operation and Functions
5-1. Pan-Tilt Head
5-1-1. Control Connectors
[Receptacle unit in the rear of the pan-tilt head]
①
MODE SW
Specify the transmission mode, installation type, and image format. After any changes, restart
the unit.
Switch
Setting Details
1
Transmission mode (OFF: RS-232C, ON: RS-422)
2
Installation type (OFF: upright installation, ON: suspended from a ceiling)
3
,
4
3
（
59.94/50
）
4
（
1080i/720p
）
Image Format
HD-SDI
VBS
OFF
OFF
1080/59.94i
NTSC
ON
OFF
1080/50i
PAL
OFF
ON
720/59.94p
NTSC
ON
ON
720/50p
PAL
5 to
7
Not used. Leave the switch set to OFF.
8
OFF: Normal mode, ON: high-speed mode
②
PWR LED
Lit in green when on.
③
DC-IN
Inlet for supplying DC power. Using the included power cord, connect the unit to a DC power
source suitable for the location of installation. (12 V, 30 W or more capacity recommended.)
④
RS-232C (see pin assignment at right)
A
n input for remote control. Connect one end of
an RS-232C cable here and the other end to the
operation unit.
Ensure that the cable connector can fit through an
opening 36.5 mm in diameter.
DC cable
fastener
①
⑤
②
③
④
⑥
⑦
⑧
⑨
⑩
⑫
⑪
④
RS-232C
（
D-sub9P
：
DTE
）
Pin No.
Signal
2
RD (IN)
3
SD (OUT)
4
ER (
fi
xed at +12V)
5
GND
7
RS (
fi
xed at +12V)
To connect a computer, use a cross-cable.
