OSD Menu
43
Sub Menu
Setting Options (Factory default)
Area Marker1, 2
1
There are two types of [Area Marker]: 1 and 2, which share the same settings. [Area Marker] is used
to check a specific area using a rectangular box.
Enable
On, Off
Switches the area marker On, Off.
H Position
0 to 3830
Sets the start position (x-coordinate) to draw the rectangle (in increments
of 2).
V Position
0 to 2150
Sets the start position (y-coordinate) to draw the rectangle (in increments
of 2).
Width (dot)
10 to 3840
Sets the width of the rectangle (in increments of 2).
Height (dot)
10 to 2160
Sets the height of the rectangle (in increments of 2).
Mask
Black
Half
Off
Switches the mask color (in the marker).
Line
On, Off
When [Mask] [Black] or [Half]
Turns On/Off the outlines of the rectangular box.
Line Width
Thick
Normal
Thin
When [Mask] [Off] or [Line] [On]
Sets the width of the area marker line.
Line Color
White, Red, Green,
Blue, Yellow, Cyan,
Magenta, Gray
When [Mask] [Off] or [Line] [On]
Sets the color of the area marker line.
Line Brightness
High, Low, Half
When [Mask] [Off] or [Line] [On]
Sets the brightness of the area marker line.
