Canon DADF-P1, Service Manual

Page: 42 / 90

Chapter 3
3-2
F-3-7
2) Remove the two screws [3], and then detach the front cover [4].
F-3-8
3.2.3.2 Removing the Feeder Cover
0010-3925
1) Remove the screw [1] and positioning pin [2], and then detach the feeder
cover [3].
F-3-9
3.3 Drive System
3.3.1 Pickup Motor
3.3.1.1 Removing the Rear Cover
0010-6190
1) Open the feeder cover.
2) Move to the back of the machine, remove the two screws [1], and then
detach the rear cover [2].
F-3-10
Remove the rear cover with the two claws [3] released.
3.3.1.2 Removing the Pickup Motor
0010-3927
1) Disconnect the connector [1], and then remove the tension spring [2].
2) Remove the two screws [3], and then remove the pickup motor [4]
together with the adjusting plate.
F-3-11
3.3.1.3 Installing the Pickup Motor
0010-3928
1) Attach the tension spring [1] to the adjusting plate and motor base, and
then install the motor in such a manner that the motor pulley and the
timing belt are engaged.
2) Install the pickup motor [3] together with the adjusting plate using two
screws [2].
3) Connect the connector [4].
[1]
[2]
[3]
[4]
[3]
[2]
[1]
[1]
[3]
[2]
[3]
[4]
[1] [3]
[2]