3 System Connections
Preparing the Camera Unit
20
Some settings cannot be changed using the Camera Remote application after the installation is completed.
Make sure to change all the necessary settings on the main capture camera and the lens before the final
installation.
Connecting the Power Supply to the Main Capture Camera
For details about operating the camera, refer to the instruction manual
of the camera used.
1.
Attach the DC coupler to the main capture camera.
Attaching a Lens Supporter to the Lens
When using an EF70-200mm or EF100-400mm lens, attach the
corresponding lens supporter to the lens using an hex head bolt (M5).
Adjusting the Camera Mounting Bracket’s Positioning Element
The positioning element on the camera mounting bracket is only
necessary when using a lens that does not require a lens supporter. When
using one of the lenses that require a lens supporter (see above), adjust
its orientation as necessary.
To do so, loosen the cross head screw so the positioning element is
slightly raised, rotate it to a position where it does not obstruct the lens
and tighten the screw.
Bottom
