Canon CP-300, User Manual, Page: 62 / 204

58
Table of
C
o
nt
ents
Preparation/
Setup
Pr
int U
sing
a C
omput
er
Appendix
Index
P
rint/Sa
ve
Input/Edit
Names of
Components
M
aint
enanc
e/
Print
er S
ettings
Tr
ouble
-
shooting
6
Use [
▲
] or [
▼
] to select "Left" and enter "5" (margin).
The value can be set by entering numbers
or using arrow keys ([
◀
] / [
▶
]).
Alignment
ɻɻ
Centered
Left : 5
㎜
[2 to 5]
Right : 5
㎜
[2 to 5]
7
Press the [Enter] key.
The display returns to the character
input display. Input the characters.
Cut length and alignment can be
checked on the display.
˛
/
NOTE
• The cut length and alignment can be set for each page.
• Depending on the character size, some cut lengths cannot be specifi ed.
• If you want to change the cut length of all pages, use "Batch Setting."
(P.59)
In Batch
Setting, the "Cut Length," and "Alignment," settings are applied to all pages.
• Approximately 60 mm from the print start position, there may be a slight diff erence
between the specifi ed cut length and the print result.
• Depending on your print media and environment, the cut length and margins may
diff er from the settings. If the results are not as expected even after setting the cut
length and margins, fi ne-tune the cut length and print position. For more information
on fi ne adjustment of the cut length and print position, refer to
"Fine Adjustment of Print
Position and Cut Length (P.80)"
.
• When the print media is a label, if the cut length is less than 8.0 mm, the alignment is
"Centered" and the settings cannot be changed.