Canon Color Universal Send Kit-Q1, Service Manual

Page: 33 / 96

Chapter 2
2-13
F-2-11
Where reception/printing is concerned, the following protocols and applications apply:
LPD, RAW, SMB, FTP, HTTP (IPP), PDF, SMTP
Where setup/reference is concerned, the following protocols apply:
SNMP, HTTP (RUI)
2.1.20 Protocol-Related Setup
0020-7941
Protocols and applications make use of specific ports. If left "open," an unused protocol can prove to be a security risk. In this regard, it is made possible to enable/
disable (on/off) the ports individually.
Protocols and Applications Concerned
T-2-3
2.1.21 RUI Log-in Procedure
0020-7942
In 'Additional Functions', if 'System Manager ID' and 'System Password' are selected under System Settings>System Manager Settings, a press on the User Mode
button of the RUI will bring up a screen that asks for the appropriate ID and password.
Previously, as many log-in attempts as needed might be made (i.e., failing to type in the correct ID/password). With the current version, making the following service
mode setting will cause port 8000 to close for 3 min if the log-in operation fails 3 times within 3 min, during which time log-in operation will remain impossible:
COPIER>OPTION>USER>RUI-RJT
2.1.22 cc/bcc Settings
0020-7943
In addition to the address used in the e-mail, transmission may be controlled by means of cc (carbon copy) and bcc (blind carbon copy).
This applies to e-mail addresses only, and is available when 'Send Transmission Function' is enabled.
In the case of 'cc' and 'bcc' alone, as many as 64 addresses may be specified. Including 'To', a total of 256 addresses may be used.
Additional Functions
LPD Additional Functions>System Settings>Network Settings>TCP/IP Settings>LPD Orint Settings
RAW Additional Functions>System Settings>Network Settings>TCP/IP Settings>RAW Print Settings
SMB Additional Functions>System Settings>Network Settings>SMB Server Settings>Use SMB Server
HTTP Additional Functions>System Settings>Network Settings>TCP/IP Settings>Use HTTP
IPP Additional Functions>System Settings>Network Settings>TCP/IP Settings>IPP Print Settings
FTP Additional Functions>System Settings>Network Settings>TCP/IP Settings>TCP/IP Settings>FTP Print Settings
SNMP Additional Functions>System Settings>Network Settings>SNMP Settings>Use SNMPv1 and Use SNMPv3