Canon Color imageCLASS MF8580Cdw, Service Manual

Page: 174 / 401

4
4
4-104
4-104
Disassembly/Assembly > Fixing System > Removing the Fixing Assembly > Procedure
Disassembly/Assembly > Fixing System > Removing the Fixing Assembly > Procedure
Fixing System
Location
[1]
[4]
[3]
[2]
No. Parts Name Main Unit Remarks Reference Adjustment
during parts
replacement
[1] Fixing Assembly Product
Configuration
- (Refer to page 4-104) -
[2] Fixing Motor Unit Product
Configuration
M4 (Refer to page 4-111) -
[3] Fixing Pressure Roller Fixing
Assembly
- (Refer to page 4-110) -
[4] Fixing Film Unit Fixing
Assembly
- (Refer to page 4-106) -
F-4-224
T-4-23
Removing the Fixing Assembly
■ Preparation
1) Removing the Right Cover. Refer to page 4-20.
2) Removing the Left Cover. Refer to page 4-17.
3) Removing the Rear Upper Cover. Refer to page 4-24.
4) Removing the Rear Cover. Refer to page 4-24.
5) Removing the Rear Lower Cover. Refer to page 4-25.
6) Removing the Rear Cover Rib Unit. Refer to page 4-27.
7) Removing the Duplex Printing Reverse Drive Unit. Refer to page 4-85.
■
Procedure
CAUTION:
When removing the fixing unit, be sure to turn OFF the power.
Since the fixing assembly is extremely hot just after the printing, do not handle it unless
it cools down completely.
If you touch the high-temperature assembly, it may cause a burn.
1) Remove the claw [2] of the harness guide [1] and disconnect the connector [3].
[1]
[2]
[3]
F-4-225