Canon CLC5151, Sending And Facsimile Manual

Page: 451 / 476

Report and List Samples 14-7
14
Ap
pe
ndix
■
ST. TIME (Start Time)
The date and time (in 24-hour notation) at which the document started to transmit are printed.
■
USAGE T
The time taken (in minutes and seconds) to send the document from start to finish is printed.
■
PGS.
The number of pages that were sent successfully to the recipient is printed.
■
RESULT
If the documents were transmitted successfully, "OK" is printed.
If a sending error occurred, "NG" (No Good) is printed.
If a sending error occurred, the page number in which the error occurred and the error code number are
printed.
Multiple Communication Result Report
This report is used to check whether documents were sent successfully to the intended
destinations when a sequential broadcast transmission was performed.
You can set whether to automatically print a Multiple Communication Result Report after
sending documents. (See "Fax TX Report," on p. 12-8.)
NOTE
•
This mode is available only if the optional Super G3 FAX Board is installed.
•
You can also print a Multi TX/RX Report with an image of the sent original attached to it. (See "Fax TX
Report," on p. 12-8.)
0 1 4 2
1 2 3
1
0 1 2 X X X X X X X
- - - - -
0 9 8 X X X X X X X
1 4 / 0 2 / 2 0 0 6 T U E 1 1 : 1 8 F A X 0 1 2 X X X X X X X i R C4580i 0 0 1
*******************************
*******************************
F A X M U L T I T X R E P O R T
.
*** ***
JOB NO.
DEPT. ID
PGS.
TX/RX INCOMPLETE
TRANSACTION OK
ERROR