Canon CLC5151, Sending And Facsimile Manual

Page: 412 / 476

When Problems Occur 13-8
13
T
roub
lesh
oot
ing
Other Situations
Transmissions are slow.
Q Are documents being sent at a high resolution?
A It is recommended that you send documents containing text only in a lower resolution. (See
"Resolution," on p. 3-13.)
Fax transmissions are slow (if the optional Super G3 FAX Board is installed).
Q Is the ECM TX or ECM RX set to 'On'?
A Set ECM TX and ECM RX to 'Off'. (See "ECM Transmission," on p. 9-42, and "ECM
Reception," on p. 9-47.)
Q Was the original type set to 'Text/Photo' when sending the document?
A Select 'Text' from the Original Type drop-down list if the original does not contain any photos.
(See "Scan Exposure and Original Type Settings," on p. 3-15).
Cannot use fax information services (if the optional Super G3 FAX Board is installed).
Q If your machine is connected to a rotary pulse line, is your machine set for tone dialing?
A Set the machine for tone dialing to use fax information services. (See "Fax Information
Services," on p. 7-9.)
Q Did you receive an instruction from the sender to set the machine to receive?
A Press [RX Start]. (See "Fax Information Services," on p. 7-9.)