6. SPECIAL TOOLS
Clean spurs by using the spur cleaner in case spur marks are left on the print images.
Special tool (part number)
Remarks
Spur cleaner (QY9-0055-000)
For cleaning spurs
Usage
1) Moisten the fabric part of the spur cleaner with approx. 5 cc of water.
Moisten the fabric with the water, as shown below, so that the fabric absorbs the water
from end to end.
Be careful not to moisten the fabric with too much water. In case too much water is
used, there is the possibility that water will be wrung from the spur cleaner when
passing through the paper feed roller, spread inside the printer, and cause failure.
2) Turn on the power of the printer. Remove the paper from the ASF to set the spur
cleaner with the fabric-affixed part of the cleaner face-up and to the top.
3) Press the
RESUME
button, and release it after the beeper sounds once. The spur
cleaner is fed and stops at the print start position.
4) Press the
RESUME
button again, and release it after the beeper sounds once. The spur
cleaner is delivered. Repeat procedures 3) to 4) approx. 5 times in case of heavy soiling.
5) Set a single sheet of paper to the ASF to repeat procedures 3) and 4). (To remove the
moisture remaining in the paper feeding path.)
13
Fabric (white-colored)
Spur cleaner
Part moistened with water
Be careful that the water
is absorbed by the
fabric from end to end.
Transparent film
Fabric (white-colored)
Spur cleaner
Summary of Contents for BJ M70
Page 1: ...REFERENCE MANUAL Oct 1999 ...
