1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
10-31
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Entering the fax number is required again after pressing [Start].
Is <CONFIRM FAX NO.> set to <ON>?
When <CONFIRM FAX NO.> is set to <ON>, you need
to enter the fax number again after pressing [Start].
(See “Confirming Entered Fax Numbers,” on p. 8-3.)
Receiving Problems
Cannot receive a fax automatically.
Is the machine set to receive automatically?
For the machine to receive faxes automatically, the
receive mode must be set to <FaxTel>, <FaxOnly>,
<AnsMode>, or <NET SWITCH>. If you have set
<AnsMode>, confirm that an external telephone
with built in answering machine is connected to the
machine and that it is turned on with an outgoing
message properly recorded. (See “Basic Receiving
Method,” on p. 4-25.)
Q
A
■
Q
A
Are documents stored in memory, leaving little or
no memory available?
Print, send, or delete any documents stored in
memory.
Has an error occurred during reception?
Check the LCD for an error message. (See “LCD
Messages,” on p. 10-14.)
Print an Activity Report and check for an error. (See
“ACTIVITY REPORT,” on p. 11-29.)
Is paper loaded in the machine?
Make sure paper is loaded in the machine. (See “Set
Up the Machine,” in the Starter Guide.)
Is the telephone cable connected properly?
Make sure the cable is connected properly. (See
“Before FAX Setting,” in the Starter Guide.)
Q
A
Q
A
A
Q
A
Q
A
