Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6943465 Rev A
Page 6 of 7
Step 8: UTP Port Set-up
The HS8000 comes with two optical ports and six 10/100 UTP ports. The optical ports are set for
100Mbps full duplex and can not be altered. However, the UTP ports can be configured for 10 or
100Mbps, half duplex or full duplex, or auto negotiation. To configure the UTP ports, access the
Port Menu screen by typing “2” from the Main Menu. Enter the port number, from 2 to 7, and
make the necessary changes for the application.
CANOGA PERKINS CORP.
HS8000 Hardened Ethernet Switch
Port Menu
Port # Interface Speed Duplex Status
1 Fiber 100 FDX DOWN
2 RJ-45 100 FDX DOWN
3 RJ-45 100 FDX DOWN
4 RJ-45 100 HDX DOWN
5 RJ-45 100 HDX DOWN
6 RJ-45 100 HDX DOWN
7 RJ-45 100 HDX DOWN
8 Fiber 100 FDX DOWN
Enter Port Number to View/Config or 0 to Exit: 2
Figure 9. Port Menu
Port View/Configuration for Port No: 2
Interface RJ-45
1. Link Status UP
2. Auto Neg OFF
3. Speed 100
4. Duplex FDX
STP State NO STP
5. STP Priority
6. STP Path Cost
7. QOS Priority LOW
8. Clear Stats
0. Exit this menu
Enter Selection by number: 3
Transmit Statistics Receive Statistics
Packets:
0 Packets:
0
Bytes:
0 Bytes:
0
Dropped Pkts:
0 Dropped Pkts:
0
Collisions:
0 Align Errors:
0
Pause Pkts
0 FCS Errors:
0
Figure 10. Port Configuration