1
Index
Installation............................................ 2
Comment .............................................. 3
Frequency Question............................ 7
Interface................................................ 9
Keyboard .............................................. 10
RS-232C................................................ 12
Wand Emulation .................................. 14
OCIA...................................................... 15
System Control .................................... 16
UPC-A ................................................... 19
UPC-E ................................................... 20
EAN-13.................................................. 21
EAN-8 .................................................... 22
Code-39 ................................................ 23
Interleaved 2 of 5 ................................. 24
Industrial 2 of 5 .................................... 25
Matrix 2 of 5.......................................... 26
Codabar/NW7 ....................................... 27
Code-128 .............................................. 29
Code-93 ................................................ 30
Code-11................................................. 31
MSI/Plessey.......................................... 32
Preamble/Postamble ........................... 33
Appendix .............................................. 34
ASCII Code Table................................. 35
Hexdecimal/Decimal Table ................. 36
Installation
2
Installation
1) First of all, you must make sure that the power is
disconnected form your equipment before connecting
the scanner. Beside, you also have to check the
cable connector of the scanner match your
equipment interface correctly.
2) Boot up your computer after connecting the scanner
with your equipment, the scanner will make a long
music and light the LED, above scanner to indicate a
successful power on. Trigger the button, the scan
line in front of scanner will active. Now you can start
to set programming optimal usage.
Recommened Steps
W
hen the required settings have been configured,
all settings are stored in non volatile memory of scanner
after reading
EXIT
label. There are recommended steps
as follows.
1) Set right interface of scanner for your host at
9.
First time, you may ignore it unless you want to
change the scanner into other interface usage.
2) Set interface protocol to optimize of scanner with
your host.
3) Set system control of scanner, such as specific
adjustments, indicator, scanning mode, code ID and
code name transmission which you prefer usage in
system Control at
16.
4) Set code option of scanner for your usage. You must
make sure to enable the symbology first, then
Min./Max. code length, code ID, checksum and
truncate digits are also convered.
5) Set string format of the scanner, such as preamble,
postamble, prefix, suffix, for your application at
33.
