Digital to Analog Converter
ZeroUno
DAC
–
Operating instructions
CanEVER AUDIO
®
ZeroUno
DAC
page 3
O
N /
O
F
F
The left knob is the
POWER SWITCH
.
OFF
No power to any part of the
ZeroUno
DAC
ON
ZeroUno
DAC
is powered on
V
O
L
UME
In PLAY mode turning the right knob clockwise or counter clockwise
changes the
VOLUME
(up/down) in steps of 1 dB.
While rotating the volume knob, the volume level is shown at the
display.
Volume range is -60dB
– 0dB.
DIS
P
L
AY
NOLOCK
.
USB
OOOOOOO.
Volume
.
:
.
-20dB
..
MUTE
Balance:
.
R0.5
.
PHASE+
INPUT
..
:
.
USB
In PLAY mode the display reports the status of the
ZeroUno
DAC
.
•
The first row at the display shows the LOCK on the coming signal.
•
The second row shows the VOLUME (really the attenuation) in dB.
•
The third row shows the BALANCE and the ABSOLUTE PHASE.
•
The fourth row shows the active INPUT.
When a MUTE appears at the display, there is no signal locked at the
selected INPUT and the
ZeroUno
DAC
has automatically switched to
MUTE.
S
E
T
UP
Press the
SETUP
for at least 2 seconds and LESS than 10 seconds
to enter in SETUP Mode.
The value of each parameter is visible at the display.
Press the SETUP button again to skip to the next parameter.
Rotating the right knob (VOLUME) changes the parameter values.
If no button is pressed, or the right knob is not turned within 10
seconds, the
ZeroUno
DAC
automatically stores the values shown at
the display and switches back to the PLAY/MUTE mode.
All selected parameters are stored in a non volatile memory, to keep
the setup information after the unit is switched off.