Olimpico PowerAmp
Technical Description
Copyright
CanEVER
AUDIO®
2020-2021
page 4
Set-Up Instructions
1)
Connect the amplifier unit to the power supply unit by the
RED cable
coming with the units.
2)
Connect the speaker cables to the WBT Cu NextGen 3-way binding posts.
3)
Connect the PREAMPLIFIER by the unbalanced RCA INPUTS or by the balanced XLR INPUTS.
Flip the switches
at the
Olimpico PowerAmp
,
up
if the connection is unbalanced, or
down
if
balanced. If the switches are not properly set a hum is present at the loudspeakers.
4)
Press the MAINS SWITCH
positioned at the rear side of the power supply.
The backlight light inside the power switch lights up and the power supply no is in STANDBY.
The LED
at the power supply lights up as well.
5)
To POWER ON the amplifier unit press the knob
at its front panel.
The
Olimpico PowerAmp
powers-on only if the power supply is already in STANDBY.
When the amplifier unit is ON. the second LED
at the Power Supply lights up as well.
6)
Inside the power supply is an extra EMI FILTER.
This filter is in use, when the related switch
at the back of the power supply is flipped DOWN.
If problems are experienced with the RCD switches installed in the mains of the building, please
read pages 8 and 9 in the chapter “The
Power Supply”
of the technical description.