EN
73
PAUSING THE MACHINE
l
Keep the
START/PAUSE
button pressed
for about
2
seconds
(the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
l
Press the
START/PAUSE
button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
programme selector to the
OFF
position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
l
This button allows to delay the start of the
programme from
30 minutes
(
1 hour
on
some models) to
24 hours
in
30 minutes
intervals (
1 hour
on some models).The
delay selected is shown on the display.
l
After pressing the
START/PAUSE
button
the time showed decrease minute after
minute.
l
It's possible transform a cycle from
automatic to programmed, up to
3
minutes
after the start of the cycle.
l
The progressive pressure increases the
time in
10 minute
intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly for 3 times.
This button allows you to store the options
set on a cycle.
MEMORY:
select the programme and the desired
options, then press the button
MEMO
for
3
seconds
(before starting the cycle). The
writing
MEMO
(all the digit on
some
models) will blink for
2 seconds
and the
options connected to the cycle selected will
be set.
RECALL:
after the selection of the cycle press the
button
MEMO
for recall the stored options
(not the cycle).
l
This button allows to set the desired
dryness level editable option up to
3
minutes
after the starting of the cycle:
Ready to Iron
: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger
: to get garment ready to
be hang.
Dry wardrobe
: for laundry that can be
directly stored.
Extra-dry
: to get completely dry
garments, ideal for full load.
l
This appliances is equipped with
Drying
Manager
function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is
indicated by flashing the light indicator
corresponding to the degree of drying
reached.
DELAY START button
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
MEMO button
The delay start function can't be
memorized.
DRYING SELECTION button
Summary of Contents for RapidO H11A2TCEX-S
