Candy PL40, Instruction Booklet

Page: 55 / 102

Using the grids
The panstand grids are designed to make the appliance easy and safe to use. Always check the
panstand grids are properly positioned before using the appliance. Furthermore, always check the
protective rubber feet are all present and correctly positioned.
Grid for small pots or pans (Fig. 3)
This is placed on top of the auxiliary burner grid (the smallest one) when pots or pans of reduced
diameter are used, to avoid unbalancing.
INSTALLATION INSTRUCTIONS
Important!
These instructions are intended for qualified technicians.
The appliance must be installed correctly, in compliance with current laws.
Before carrying out any operation on the appliance, it must be disconnected from the
electricity supply.
Fitting the appliance in the worktop
The cooktop may be fitted into any worktop, as long as it is heat resistant (minimum temperature of
90°C).
The dimensions of the hole to be made in the worktop and the minimum distances between rear and
side walls and those above the appliance are shown in figures 5 and 6.
Bear in mind that:
)
If the cooktop is installed without an oven below it, a separator panel must be placed between the
bottom of the cooktop and the housing below it, at a minimum distance of 10 mm.
If the cooktop is installed over an oven, place a separator panel at a minimum distance of 15 mm and
follow the oven manufacturer's instructions, ensuring nonetheless sufficient aeration as specified in fig.
7.
In any event, the electrical connection of the two appliances must be carried out separately,
both for electrical purposes and to facilitate removal.
It is advisable to use an oven equipped with an internal forced cooling system.
Fixing the cooktop
To fix the cooktop in the housing, proceed as follows:
)
Position the special gasket supplied along the outer perimeter of the worktop, following the
diagram shown in fig. 5, so that the ends of the gasket meet exactly without overlapping.
)
Position the cooktop into the worktop, taking care to ensure it is placed exactly in the centre.
)
Fix the cooktop to the worktop using the special brackets supplied (A), as shown in fig. 8.
Correct installation of the sealing gasket (C) ensures complete protection against infiltration of
liquids.
)
The brackets must be fixed in the holes mark to you from the fig. 8
53