Candy GO 4 1064 D, User Instructions, Page: 66 / 67

66
CHAPTER 13
FAULTS SEARCH
FAULT CAUSE REMEDY
Mains plug not plugged in Insert plug 1. Does not function on any
program
Mains switch not on Turn on mains switch
No power Check
Electric circuit fuses failure Check
Load door open Close load door
See cause 1 Check 2. ad water Does not lo
Inlet tap turned off Turn on water inlet tap
Timer not set correctly Set timer on correct position
Discharge tube bent Straighten discharge tube 3. Does not discharge water
Odd material blocking filter Check filter
4. Water on floor around
washing machine Leak from the washer between the tap
and inlet tube Replace washer and tighten the tube
on the tap
The washing machine has not discharged
water Wait a few minutes until the machine
discharges water 5. Does not spin
“No spin” setting (some models only) Turn the program dial onto spin
setting
6. Strong vibrations during
spin Washing machine not perfectly level Adjust special feet
Transport bracket not removed Remove transport bracket
Washing load not evenly distributed Dis the washing evenly tribute
7. Display reads error 0, 1, 5,
7, 8, 9 - Call service.
8. Display reads error 2 No water fill. Check water supplies are on.
9. Display reads error 3 No pump out. Check drain is clear. Check drain
hose is not kinked.
10. Display reads error 4 Machine overfilled with water. Turn off water supply to machine.
Call service.
If dy Technical Assistance Centre. For prompt servicing, give the model
of side of the porthole or on the guaran-
te
the fault should persist, contact a Can
the washing machine, to be found on the label placed on the cabinet in
e certificate.
Important!
1. Th
ates may produce the following effects: e use of environment friendly detersives without phosph
- sence of zeolites in suspension. This The discharge rinse water may result cloudier due to the pre
does not compromise the efficiency of the rinses.
-
nd of the washing cycle. This does The presence of white powder (zeolites) on the washing at the e
n r. ot remain incorporated in the fabric and does not alter the colou
- nce of foam in the last rinse water which is not necessarily a sign of inadequate rinsing. The prese
- The non- washing machine detersives are ionic surface-active agents present in the composition of
o all quantities, may produce visible ften difficult to remove from the washing itself and, even in sm
signs of the formation of foam.
- Carrying out further rinses, in cases such as this, is not useful.
2. If your washing machine fails to function, carry out the above-mentioned checks before calling the
Candy Technical Assistance Service.